Panasonic KX-TD1232 - Page 4

4
Display (If disabled): Rejected
The Cell Station (CS) may not be connected or not working. After connecting the CS
or resetting the PBX, wait for at least one minute and try again from the beginning.
6.
Press the
POWER
button for a while (about 5 seconds).
7.
Press the
FUNCTION
button.
8.
Press the
FUNCTION
button again.
Or Press the
UP/DOWN
button repeatedly until “PROGRAM” is selected and then press the
SELECT
button.
9.
Press the
UP/DOWN
button repeatedly until the display below is selected.
Display: INITIAL SETTING
10.
Press the
SELECT
button.
11.
Press the
UP/DOWN
button repeatedly until the display below is selected.
Display: REGISTRATION
12.
Enter the
SELECT
button.
13.
Press the
UP/DOWN
button repeatedly until the desired
DECT system number
is
selected.
Display example:REGISTRATION
DECT-SYS 1
DECT-SYS 2
14.
Press the
SELECT
button.
15.
Enter the
PS password
.
16.
Press the
AUTO/OK
button.
You will hear a confirmation tone and the display changes as follows.
Display example: DECT-SYS LOCK
ENABLE
DISABLE
17.
Enter the
UP/DOWN
button to select “DISABLE” or “ENABLE” for the System Lock.
Display example: DECT-SYS LOCK
(With a PS)
Display example: ENTER PASSWORD
=--------
Display example: ENTER PASSWORD
=****----
Display: EXECUTING