Station Features and Operation (DPT/SLT)
230 User Manual
4.3.63 Operator Call
Allows you to call an operator within the system. Two extensions can be assigned as Operator
1 and 2.
Conditions
• If no operator is assigned, this feature is not available and you will hear a reorder tone after
dialing the feature number.
• The call is routed to Operator 1 first. If Operator 1 is busy, then it is routed to Operator 2.
Through System Programming, it is possible to change the routing so that Operator 1 and
Operator 2 are called simultaneously when the operator is called.
Programming Guide References
[990] System Additional Information
Any Telephone
Dial 0.
Lift the handset or press
SP-PHONE/MONITOR.
0
To Next Page
Loading...
