Panasonic KX-TD208 - Basic Programming; Before Programming; Programming Type Selection; Entering Programming Mode

B
C
D
• • • 6 • • •
BBaassiicc PPrrooggrraammmmiinngg
Some programming is required for basic operation. Check your contract
with the telephone company and program as needed. The following flow
chart will tell you which programming is required for your system. Please
program your system accordingly.
Your contract is:
1: Point-to-Multi-point
2: Point-to-Point
Do you want to specify
the receiving extension?
Does your contract apply
to a DDI service?
Programming type selection
A
1 2
No
Yes No Yes
Connect a tone-type single line telephone to jack number 1 for programming.
Check: • Your telephone is on-hook.
• No calls are on hold at your telephone.
Programming
5
1
2
3
4
Password (Default)
Off-hook Dial tone 3
extension no.
CLIP/COLP no.
20 digits max. (0 ··· 9)
[404] CLIP / COLP Number Assignment
21 through 28,
31 through 34,
301 through 308
(ISDN ext.),
300 (all ISDN ext.)
4
0
X
4
(Continued)
X – CLIP / COLP Classfication
1 : CLIP no. Business 2 : CLIP no.-Private
3 : COLP no.-Business 4 : COLP no.-Private
: All
Type
Step 2. Program [404] to all the types A, B, C, D.
Step 1. Enter into the programming mode.
Before programming
(1,2, )
ISDN
port no.
(1 ··· 4, )