L 3 Features
3-98 Features
Line Preference – Outgoing (Idle Line / No Line / Prime Line)
Description A proprietary telephone user can select a desired outgoing line
preference to originate calls from the following three line
preferences:
(1) Idle Line Preference:
When you go off-hook, you are connected to an idle line. An
idle line is automatically selected from the pre-assigned lines.
(2) No Line Preference:
No line is selected when you go off-hook. You must select a
line to make a call.
(3) Prime Line Preference:
When you go off-hook, you are connected to the pre
assigned line. Assign a line as your prime line beforehand.
Conditions • Setting a new line preference feature cancels the previous setting.
• To set Prime Line Preference, one prime line is selected from intercom
or outside lines.
• The outside lines used by users must be connected by programming.
• To select Idle Line Preference, outside lines available for the user
should be programmed. Also outside lines available for Automatic
Line Access should be assigned.
• The user can override the Idle / Prime Line Preference temporarily to
select a specific line. To select it, press the desired line access button
(INTERCOM or CO button) before going off-hook or pressing the SP-
PHONE / MONITOR button; or if Full One-Touch Dialing is enabled,
press One-Touch Dialing, DSS (Direct Station Selection), REDIAL, or
SAVE button.
Programming References
Section 4, System Programming
[005] Flexible CO Button Assignment
[103] Automatic Access Outside Line Assignment
[400] Outside Line Connection Assignment
[605]–[606]
Outgoing Permitted Outside Line Assignment — Day / Night
Station Programming.......................................................User Manual
Flexible Button Assignment – Loop-CO (L-CO) Button,
Single-CO (S-CO) Button
Preferred Line Assignment – Outgoing
Feature References Section 3, Features
Outside Line Connection Assignment – Outgoing
Operation References Basic Operation
—User Manual Making Calls
To Next Page
Loading...
