3 Features S
Features 3-141
(5) Dial Number
Outgoing call: shows the other party’s telephone
number (maximum 25 digits). Valid digits are 0
through 9, , #, P (if the PAUSE button is pressed), or
the mark “=” (if a host PBX access code is entered).
Received call: shows <I>. If a Caller ID is assigned to
the other party, it shows <I>, number and name.
(6) Ring : shows the ring duration of the incoming call in
Minutes / Seconds.
(7) Duration : shows the duration of the call in Hours /
Minutes / Seconds.
(8) Acc Code (Account Code): shows the account code
appended to the call.
(9) CD (Condition Code): shows call handling type with the
following codes:
TR: Transfer
FW: Call Forwarding to Outside Line
RC: Received an incoming call
AN: Answered an incoming call
NA: Unanswered an incoming call
Conditions • Connect a printer to the Serial Interface (RS-232C) connector of the
main unit. After connecting a printer, do not press the RETURN key, if
provided on the printer, for 10 seconds.
• When programmed for outgoing toll calls only, printing occurs only for
calls which start with the numbers stored in any Denied Code Table
from levels 2 to 6. If Automatic Route Selection (ARS) is employed,
the modified number is checked against these tables.
• This system can store information of up to 100 calls. If more calls are
originated or received, previous records are deleted starting with the
oldest one.
• It is possible to select the SMDR format for an incoming call with
Caller ID, the caller’s number only or caller’s number and name, by
program [990], Field (41).
• It is possible to select whether the SMDR prints out received incoming
calls (RC) and answered incoming calls (AN) information by program
[990], Field (42).
• This data is not deleted when you reset the system.
• If the system clock is not set by System Programming or if the calendar
IC is out of order, the date and time will not be printed out.
• If the FLASH signal is manually sent during a conversation, the call
record is printed and a new record is started.
To Next Page
Loading...
