3 Features S
Features 3-147
System Programming with Personal Computer
Description This system can be programmed and administered using a personal
computer. The Serial Interface Manual and its floppy disk are
required to perform this feature.
On-Site Programming
By connecting a personal computer (PC) to your system, system
programming and maintenance can be performed locally.
Connect the PC to the Serial Interface (RS-232C) port provided.
The main unit has an Serial Interface (RS-232C) port which can be
used for either system administration or Station Message Detail
Recording (SMDR).
Conditions • A proprietary telephone can be used to perform System Programming.
• Access to System Programming is allowed only one at a time.
• To access system administration, a valid password must be entered.
The password is factory-programmed and can be changed.
• System administration can be performed on-line except for the
procedures of the diagnosis.
If the system goes off-line, the system functions as if it was in power
failure. (Refer to Power Failure Transfer feature.)
Programming References
Section 4, System Programming
[107] System Password
Feature References Section 3, Features
System Programming with Station Message Detail
Proprietary Telephone Recording (SMDR)
Operation References Not applicable.
To Next Page
Loading...
