4.3 System Programming
Automatic Access Outside Line Assignment
103
System Programming 4-37
Description Assigns the sequence in which outside lines will be accessed when
in Automatic Line Access mode. When a user dials the feature
number for automatic line access (default=9) or presses the Loop-
CO button, an idle line is searched for in the programmed outside
line order.
Selection • Outside line number: 1 through 3 in desired order
Default 123
Programming 1. Enter 103.
Display: 103 AUTO CO
2. Press NEXT.
Display example: Access:123
3. Enter the outside line numbers in priority from top to
bottom.
To delete the current entry, press CLEAR.
To change the current entry, press CLEAR and enter the new order.
4. Press STORE.
5. Press END.
Conditions • Automatic Line Access feature works only if the Automatic Route
Selection mode is turned off in program [312] “ARS Mode”.
Feature References Section 3, Features
Line Access, Automatic Line Preference – Outgoing
Line Access, Direct
To Next Page
Loading...
