4.3 System Programming
Automatic Hold by CO / DSS Button
108
4-42 System Programming
Description Enables or disables automatically holding an outside call when a
DSS (Direct Station Selection) button or a CO button on a
proprietary telephone is pressed. Through this assignment, each
button acts as follows:
— Pressing the DSS button holds an outside call and quickly
transfers it to an extension without pressing the TRANSFER
button.
— Pressing another CO button holds the current outside call.
Selection • Button: DSS or CO
• Enable / Disable
Default DSS button – Enable, CO button – Disable
Programming 1. Enter 108.
Display: 108 AUTO HOLD
2. Press NEXT to program the DSS button.
Display example: DSS XFER:Enable
3. Keep pressing SELECT until the desired selection is
displayed.
4. Press NEXT to program the CO button.
Display example: CO Hold :Disable
5. Keep pressing SELECT until the desired selection is
displayed.
6. Press STORE.
7. Press END.
Conditions This assignment applies to all DSS and CO buttons on all proprietary
telephones in the system.
Feature References Section 3, Features
Automatic Hold by CO Button
One-Touch Transfer by DSS Button
To Next Page
Loading...
