4.3 System Programming
Caller ID Code Set
110
System Programming 4-43
Description Sets the identification code of the calling party (Caller ID Code) to
utilize a Caller ID Service provided by a specific central office
(CO). If an ID Code transmitted from the CO is found in the Caller
ID Code Table, the caller’s ID Code or name given to the code in
program [111] “Caller ID Name Set” is displayed on the telephone.
This allows the called party to recognize the caller.
Selection • Location number: 001 through 100
• Caller ID Code: 11 digits (max.)
Default
All locations – Not stored
Programming 1. Enter 110.
Display: 110 CALLER ID #
2. Press NEXT.
Display: Location NO?→
3. Enter a location number.
To enter location number 001, you can also press NEXT.
Display example: 001:Not Stored
4. Enter a Caller ID Code.
To delete the current entry, press CLEAR.
To change the current entry, press CLEAR and enter the new code.
5. Press STORE.
6. To program another location, press NEXT or PREV, or
SELECT and the desired location number.
7. Repeat steps 4 through 6.
8. Press END.
Conditions • Each Caller ID Code has a maximum of 11 digits, consisting of 0
through 9.
• Program [111] “Caller ID Name Set” is used to give names to the Caller
ID Codes.
If an ID Code is assigned a name, the called party’s
telephone will show the name in place of the ID Code
.
• Program [406] “Caller ID Assignment” is used to enable the Caller ID
Service on an outside line basis.
Feature References Section 3, Features
Caller ID
To Next Page
Loading...
