4.4 Timer Programming
Call Duration Count Start Time
212
4-72 System Programming
Description Sets the number of seconds the system waits between the end of
dialing and the start of the Station Message Detail Recording
(SMDR) timer for outgoing toll calls. When the system has sent
out all the digits to the central office and this timer expires, the
system starts counting the call. A display telephone shows the
elapsed time of the call. The starting time and the duration of a call
are recorded in the SMDR record.
Selection Time (seconds): 0 through 60
Default 0 s
Programming 1. Enter 212.
Display: 212 CALL TIMER
2. Press NEXT.
Display example: Time: 0 sec
3. Enter the time.
To change the current entry, press CLEAR and enter the new time.
4. Press STORE.
5. Press END.
Conditions • The timer starts counting after all the digits are dialed. This timer does
not apply to incoming calls. The timer for incoming calls starts
immediately.
• You cannot leave the entry empty.
Feature References Section 3, Features
Display, Call Information
Station Message Detail Recording (SMDR)
To Next Page
Loading...
