4.6 Outside Line Programming
Dial Mode Selection
402
System Programming 4-95
Description Each outside line can be programmed for DTMF (Dual Tone Multi-
Frequency), pulse (rotary) or call blocking. This program assigns
your choice to each line.
DTMF: The dialing signals from an extension, either tone or pulse, are
converted to tone signals and transmitted to the outside line.
Pulse: The dialing signals from an extension, either tone or pulse, are
converted to pulse signals and transmitted to the outside line.
Call blocking: If your central office can receive both DTMF and pulse signals but
you are contracted for pulse, select this mode. When dialing on the
line with a touch tone telephone, only the pulse signals are sent to
the outside line.
Selection • Outside line (CO) number: 1 through 3, ( =all outside lines)
• DTMF / Pulse / C. Block (call blocking)
Default All outside lines – DTMF
Programming 1. Enter 402.
Display: 402 DIAL MODE
2. Press NEXT.
Display: CO Line NO?→
3. Enter an outside line number.
To enter outside line number 1, you can also press NEXT.
Display example: CO1:DTMF
4. Keep pressing SELECT until the desired selection is
displayed.
5. Press STORE.
6. To program another outside line, press NEXT or PREV, or
SELECT and the desired outside line number.
7. Repeat steps 4 through 6.
8. Press END.
To Next Page
Loading...
