4.6 Outside Line Programming
Host PBX Access Codes
411
System Programming 4-103
Description
Assigns Host PBX or Centrex access codes. If the system is
installed behind a host PBX or a Centrex system, an access code is
required to make an outside / Centrex call or to access Centrex
features. Up to four codes can be stored for an outside line
assigned to the line.
Selection • Outside line (CO) number: 1 through 3, ( =all outside lines)
• Access code: 1 or 2 digits, four different entries (max.)
Default All outside lines – Not stored
Programming 1. Enter 411.
Display: 411 HOST PBX #’S
2. Press NEXT.
Display: CO Line NO?→
3. Enter an outside line number.
To enter outside line number 1, you can also press NEXT.
Display example: CO1: , , ,
4. Enter an access code.
To delete the current entry, press CLEAR.
To change the current entry, press CLEAR and enter the new access code.
Display example: CO1:01, , ,
5. To enter more access codes for the same outside line, press
and enter the access codes until all the required entries
are completed.
Display example: CO1:01,08,10,22
6. Press STORE.
7. To program another outside line, press NEXT or PREV, or
SELECT and the desired outside line number.
8. Repeat steps 4 through 7.
9. Press END.
To Next Page
Loading...
