4.6 Outside Line Programming
Host PBX Access Codes (contd.)
411
4-104 System Programming
Conditions • This program is only required if a host PBX or Centrex line is
connected to the system.
• There is a maximum of four access codes per outside line. Each code
has one or two digits, consisting of 0 through 9, and .
• If conflicting access codes (such as 8 and 81) are stored for the same
outside line, the 1-digit code (8) only will be in effect.
• When the programmed codes are dialed, Automatic Pause Insertion and
Toll Restriction are applied to the calls. The programmed pause time
(in program [412] “Pause Time”) is automatically inserted after the
access code.
• To assign all outside lines to one selection, press the key in step 3.
In this case, the display shows the contents programmed for outside line
1.
Feature References Section 3, Features
External Feature Access Pause Insertion, Automatic
Host PBX Access
To Next Page
Loading...
