4.6 Outside Line Programming
Pause Time
412
System Programming 4-105
Description Assigns the length of the pause time. The programmed pause time
is automatically inserted after a line access code or a host PBX
access code programmed in [411] “Host PBX Access Codes” or
manually inserted if the PAUSE button is pressed by the user.
Selection • Outside line (CO) number: 1 through 3, ( =all outside lines)
• Time (seconds): 1.5 / 2.5 / 3.5 / 4.5
Default All outside lines – 1.5 s
Programming 1. Enter 412.
Display: 412 PAUSE TIME
2. Press NEXT.
Display: CO Line NO?→
3. Enter an outside line number.
To enter outside line number 1, you can also press NEXT.
Display example: CO1:1.5sec
4. Keep pressing SELECT until the desired time is displayed.
5. Press STORE.
6. To program another outside line, press NEXT or PREV, or
SELECT and the desired outside line number.
7. Repeat steps 4 through 6.
8. Press END.
Conditions • To assign all outside lines to one selection, press the key in step 3.
In this case, the display shows the contents programmed for outside line
1.
Feature References Section 3, Features
Host PBX Access Pause Insertion, Automatic
To Next Page
Loading...
