4.6 Outside Line Programming
Reverse Circuit Assignment
416
System Programming 4-109
Description Enables or disables Reverse Circuit detection.
Selection • Outside line (CO) number: 1 through 3, ( =all outside lines)
• Regular (no detection) / Reverse (detection)
Default Regular
Programming 1. Enter 416.
Display: 416 REV. CURRENT
2. Press NEXT.
Display: CO Line NO?→
3. Enter an outside line number.
To enter outside line number 1, you can also press NEXT.
Display example: CO1:Regular
4. Keep pressing SELECT until the desired selection is
displayed.
5. Press STORE.
6. To program another outside line, press NEXT or PREV, or
SELECT and the desired outside line number.
7. Repeat steps 4 through 6.
8. Press END.
Conditions • To assign all outside lines to one selection, press the key in step 3.
In this case, the display shows the contents programmed for outside line
1.
Feature References Section 3, Features
Reverse Circuit
To Next Page
Loading...
