4.6 Outside Line Programming
Outside Line Name Assignment
417
4-110 System Programming
Description
Assigns names of the company or customer to each outside line so that
the operator or extension user can find the destination which the caller
is trying to reach before answering. If Caller ID is assigned, each
extension can select either the initial display, Caller ID or line name.
Selection • Outside line (CO) number: 1 through 3, ( =all outside lines)
• Name: 10 characters (max.)
Default All outside lines – Not stored
Programming 1. Enter 417.
Display: 417 CO LINE NAME
2. Press NEXT.
Display: CO Line NO?→
3. Enter an outside line number.
To enter outside line number 1, you can also press NEXT.
Display example: CO1:Not Stored
4. Enter a name.
For entering characters, see Section 4.1.3 “Entering Characters”.
To delete the current entry, press CLEAR.
To change the current entry, press CLEAR and enter the new name.
5. Press STORE.
6. To program another outside line, press NEXT or PREV, or
SELECT and the desired outside line number.
7. Repeat steps 4 through 6.
8. Press END.
Conditions • There is a maximum of 24 names. Each name has a maximum of 10
characters.
•
To assign all outside lines to one selection, press the key in step 3. In
this case, the display shows the contents programmed for outside line 1.
• You can select the initial display, Caller ID or outside line name, by
Station Programming.
Feature References Section 3, Features
Display, Call Information
To Next Page
Loading...
