4.7 COS Programming
Executive Busy Override Deny
506
4-116 System Programming
Description This program is used to determine which Classes of Services (COS)
are allowed to deny Executive Busy Override. Executive Busy
Override Deny allows the user to prevent Executive Busy Override
– Extension / Outside Line from being executed by another
extension user.
Selection • COS number: 1 through 8, ( =all COS)
• Disable / Enable
Default All COS – Enable
Programming 1. Enter 506.
Display: 506 EXEC BSY DNY
2. Press NEXT.
Display: COS NO?→
3. Enter a COS number.
To enter COS number 1, you can also press NEXT.
Display example: COS1:Enable
4. Keep pressing SELECT until the desired selection is
displayed.
5. Press STORE.
6. To program another COS, press NEXT or PREV, or
SELECT and the desired COS number.
7. Repeat steps 4 through 6.
8. Press END.
Conditions • To assign all COS to one selection, press the key in step 3. In this
case, the display shows the contents programmed for COS 1.
• Program [601] “Class of Service” is used to assign a Class of Service to
each extension.
Feature References Section 3, Features
Executive Busy Override – Extension
Executive Busy Override – Outside Line
To Next Page
Loading...
