4.7 COS Programming
Off-Hook Call Announcement (OHCA)
509
System Programming 4-119
Description Enables or disables to perform the Off-Hook Call Announcement
(OHCA) on a Class of Service (COS) basis.
Selection • COS number: 1 through 8, ( =all COS)
• Enable / Disable
Default All COS – Enable
Programming 1. Enter 509.
Display: 509 OHCA
2. Press NEXT.
Display: COS NO?→
3. Enter a COS number.
To enter COS number 1, you can also press NEXT.
Display example: COS1:Enable
4. Keep pressing SELECT until the desired selection is
displayed.
5. Press STORE.
6. To program another COS, press NEXT or PREV, or
SELECT and the desired COS number.
7. Repeat steps 4 through 6.
8. Press END.
Conditions • To assign all COS to one selection, press the key in step 3. In this
case, the display shows the contents programmed for COS 1.
• Program [601] “Class of Service” is used to assign a Class of Service to
each extension.
Feature References Section 3, Features
Off-hook Call Announcement (OHCA)
Whisper OHCA
To Next Page
Loading...
