4.8 Extension Programming
Extension Group Assignment
602
4-122 System Programming
Description Assigns each extension to an extension group. Extension groups
are used for Group Call Pickup, Station Hunting, and Paging –
Group.
Selection • Jack number: 1 through 8, (-1 / -2),
( =all jacks, -1 = first part, -2 = second part)
• Extension group number: 1 through 8
Default All jacks-1/2 – Extension group 1
Programming 1. Enter 602.
Display: 602 EXT GROUP #
2. Press NEXT.
Display: Jack NO?→
3. Enter a jack number.
To enter jack number 1, you can also press NEXT.
To select the second part (-2), press NEXT after entering the jack
number.
Display example: #1-1:EXG1
4. Enter the extension group number.
To change the current entry, enter the new extension group number.
5. Press STORE.
6. To program another jack, press NEXT or PREV, or
SELECT and the desired jack number.
7. Repeat steps 4 through 6.
8. Press END.
Conditions • There is a maximum of eight extension groups. Each extension can
only belong to one group.
• For an explanation of jack numbering, see “Rotation of jack number”
on page 4-7.
• To assign all jacks to one extension group, press the key in step 3.
In this case, the display shows the contents programmed for Jack 1.
Feature References Section 3, Features
Call Pickup, Group Paging – Group
Extension Group Station Hunting
To Next Page
Loading...
