4-62 DPT Features
E 4.2 DPT Features
Emergency Call
Allows you to dial out a pre-assigned emergency number after seizing an outside line.
Up to ten emergency dial numbers can be stored per system.
Dialing
1. Lift the handset or press the SP-PHONE/MONITOR button.
2. Dial the line access code (9 or 81 through 83).
• You may press a CO button instead.
• You hear a dial tone.
3. Dial the emergency number.
Conditions
• The emergency number “911” is already stored. System Programming is required to
store other emergency numbers.
• An emergency call is allowed even in the following cases;
— in Account Code – Verified (All Calls, Toll Restriction Override) mode
— in any toll restriction level
— in Electronic Station Lockout
• If your telephone is connected to a host PBX, you must dial the host PBX line access
code after step 2.
Programming References
• System Programming — Installation Manual
[334] Emergency Dial Number Set
1
line access code
2
emergency number
3
To Next Page
Loading...
