Station Programming (Personal Programming) 2-3
2.1 Station Programming Instructions
To confirm the assigned function data
— Be sure that you are in the Station Programming mode: Press [PROGRAM] [9] [9].
1. Enter the programming access number* as follows:
- 1: Preferred Line Assignment — Outgoing
- 2: Preferred Line Assignment — Incoming
- 3: Full One-Touch Dialing Assignment
- 4: Intercom Alert Assignment
- 5: Call Waiting Tone Type Assignment
- 6: Self-Extension Number Confirmation
- 7: Live Call Screening Mode Set
†
- 81: Initial Display Selection
- 82: Bilingual Display Selection
- 9: Handset/Headset Selection
- 01: Remote Station Lock Control
(— Operator / manager only)
- 02: Call Log Lock Control, Incoming
(— Operator / manager only)
- 03: Live Call Screening Password Control
†
(— Operator / manager only)
- #: Station Programming Data Default Set
• The display shows the programmed data.
<Example>
When you press [5], the display shows:
(— The Call Waiting tone is now programmed to Tone 1.)
2. Press the HOLD (END) button.
• The display shows the initial programming mode.
— To exit the Station Programming mode: Press [PROGRAM] or lift the handset.
— If you wish to change the data, follow the programming procedure explained in this
section.
* A programming access number is required to program/confirm the function data by Station Programming.
† Available when the Digital Super Hybrid System is connected to a Digital Proprietary Telephone capable
Panasonic Voice Processing System (one that supports digital proprietary telephone integration; e.g. KX-
TVS100).
1
2
To Next Page
Loading...
