3-12 User Programming (Manager Programming)
3.2 User Programming (Manager Programming)
Extension Number Set
003
Description Assigns an extension number to each extension.
Selection • Jack number: 1 through 8 (-1 / -2)
(-1 = first part, -2 = second part)
• Extension Number: 2 to 4 digits
Default Jack 1-1 through 8-1 = 11 through 18;
Jack 1-2 through 8-2 = 21 through 28
Programming 1. Enter 003.
Display: 003 EXT NUMBER
2. Press NEXT.
Display: Jack NO?→
3. Enter a jack number.
To enter jack number 1, you can also press NEXT.
To select the second part (-2), press NEXT after entering the jack
number.
Display: #1-1:EXT11
4. Enter an extension number.
To change the current entry, press CLEAR and enter the new number.
5. Press STORE.
6. To program another jack, press NEXT or PREV, or SELECT and
the desired jack number.
7. Repeat steps 4 through 6.
8. Press END.
Conditions • There is a maximum of 16 extension numbers. Each extension number
can be two, three, or four digits, consisting of 0 through 9. The and
# keys cannot be used.
• An extension number is invalid if the first or second digits do not
match with the program [100] “Flexible Numbering, 1st through 16th
hundred extension blocks” setting. If one digit is assigned as the
leading digit, some extensions have two digits and some have three
digits. If two digits are assigned, some have three digits and some have
four digits.
To Next Page
Loading...
