Panasonic KX-TD500 - [Type of Number] Incoming-Private; Cyclic Signal Detection; Continuous Signal Detection

Group
Programming Guide 133
Parameter [Type of Number] Incoming—Private
Default Default
Value Range
1. Default
2. Unknown
3. International
4. National
5. Network Specific
6. Subscriber
Description/Function Specifies the Type of Number applied to the incoming CO calls via
ISDN Private Network.
Reference • 3.2 VPN Features (F/G)
– Virtual Private Network (VPN)
Parameter Cyclic Signal Detection
Default Check
Value Range
1. No check [Disable]
2. Check [Enable]
Description/Function Used to disconnect the trunk line when the system detects a cyclic
signal during a CO-to-CO line call by DISA or AGC.
Reference • 1.5 Attended Features (F/G)
– Direct Inward System Access (DISA)
Parameter Continuous Signal Detection
Default Check
Value Range
1. No check [Disable]
2.
Check [Enable]
Description/Function Used to disconnect the trunk line when the system detects a
continuous signal during a CO-to-CO line call by DISA or AGC.
Reference • 1.5 Attended Features (F/G)
– Direct Inward System Access (DISA)