System Programming 4-93
4.5.12 Caller ID Registration
Used to assign the Caller ID code (identification code of the calling party) to utilize Caller ID
Service provided by a specific Central Office (CO).
If an ID Code transmitted from CO is found in the Caller ID Code Table, the caller’s ID Code or
a name given to the code is displayed on the display PT, allowing the called party to recognize
the caller before answering a call.
Parameter
Value Range
(default)
Description/Function Reference
1 - 8
(1)
0001-1000
in 10 codes
increments
(0001 - 0010)
Up to 16
alphanumeric
characters
(Blank)
Up to 24 digits
consisting of 0-9,
and #.
(Blank)
Tenant No.
Entry No.
Name
Number
Specifies the tenant number to which the caller ID
codes are assigned.
(Required when “Tenant Service” is employed.)
Specifies the entry number of Caller ID codes which
you are going to program.
Specifies the name to a Caller ID code.
[Note]
• With Caller ID Service, the calling party is displayed
either by its ID Code or by its name. If the name
display is required, use this program to give a name to
a Caller ID code.
Specifies the identification code of the calling party
(Caller ID Code) to utilize Caller ID Service.
To Next Page
Loading...
