1. Before installing the service cards, remove the Guide Plate (See Fig.1) from the upper front
side of the basic shelf (and expansion shelf 1 and 2, if provided) by loosening the five
screws.
2. Install a service card (with facing the components side to the right) along with the upper and
lower guide rails. Press the upper and lower latch firmly until the upper latch is located
inside of the shelf. (See Fig.2 and Fig.3)
Please do not touch the components side of the service card.
3. After installing the service cards, attach the Guide Plate to the upper front side of the basic
shelf (and expansion shelf 1 and 2, if provided) with five screws.
If service cards are not installed properly, the Guide Plate will not be fixed.
Fig.1
(Front Side)
(Rear Side)
Upper Guide Rail
Upper Latch
(Card)
Lower Latch
Lower Guide Rail
Press
Press
Fig.2
Fig.3
To Next Page
Loading...
