Panasonic KX-TD500 - Page 320

General Features
320 Features Guide
CONF (Conference):
Used to establish a 3-party/5-party conference call.
FLASH:
Used to disconnect the current call and get another line for making a call without hanging up
(Flash). Sends a flash signal to the Central Office or host PBX to access their features (External
Feature Access).
Function:
Used to perform the displayed function / operation.
FWD / DND (Call Forwarding / Do Not Disturb):
Used to set or cancel Call Forwarding / Do Not Disturb feature.
HOLD:
Used to place a call on hold.
INTERCOM:
Used to make or receive intercom calls.
Jog Dial:
Used to adjust the volume of the handset receiver, headset, ringer and speaker. It also adjusts
the display contrast. Please refer to Section "1.1.5 Initial Setting for KX-T7400 Series" in the
User Manual.
For KX-T7431, KX-T7433 and KX-T7436 users, it is also used to select data from the Call
Directory and the System Feature Access Menu.
MESSAGE:
Used to send a message indication to another extension, and confirm and call back the message
sender.
MODE:
Used to shift the display in order to access various features.
During the Station Speed Dialing Number / Name assignment, this button is used to enter the
name assignment mode.
MONITOR:
Used for hands-free dialing operation.
PAUSE:
Used to insert a pause in a System Speed Dialing / Station Speed Dialing / One-Touch Dialing
number. With an APT, this button can also be used as the PROGRAM button.
PF (Programmable Feature):
These flexible buttons can be programmed to be a One-Touch Dialing, FWD / DND, SAVE,
Account, CONF (Conference), Answer or Release button as desired.
PROGRAM:
Used to enter / exit the Programming mode. With KX-T7220 and KX-T7250, this button can
also be used as the PAUSE button.
REDIAL:
Used for Last Number Redial.
SAVE:
Used to store a dialed telephone number for Saved Number Redial.
SELECT:
Used to select the displayed function or to call the displayed phone number.
SHIFT:
Used to access the next level of Soft button function.