Panasonic KX-TD816 - Automatic Callback Busy (Camp-On)

2.2 System Programming
108 General Programming
[136] DID / DDI Number Assignment
Description
Assigns the Direct Inward Dialling (DID) number which is converted from the DID subscriber
number using the programmes [433] DID / TIE Subscriber Number Removed Digit and
[434] DID / TIE Added Number. And also assigns the Direct Dialling In (DDI) number. If
the converted number matches the number assigned in this programme, it reaches the
destination assigned in programme [137-138] DID / DDI Extension – Day / Night.
Selection
• Location number:
001 through 200
• DID / DDI number:
16 digits (max.)
Default
All locations – Not stored
Programming
1.
Enter
136
.
Display: 136 DID NUMBER
2.
Press
NEXT
.
Display: Location NO?
3.
Enter a
location number
.
To enter location number 001, you can also press
NEXT
.
Display example: #001:Not Stored
4.
Enter a
DID / DDI number
.
To delete the current entry, press
CLEAR
and enter the new number.
To assign no number, press
CLEAR
.
5.
Press
STORE
.
6.
To programme another location, press
NEXT
or
PREV
, or
SELECT
and the desired
location number
.
7.
Repeat steps 4 through 6.
8.
Press
END
.
Conditions
• There is a maximum of 200 DID / DDI numbers. Each DID / DDI number can be one
through 16 digits, consisting of
0 through 9
and (wild card).
• If the same DID / DDI number is assigned to different locations, only the number at the
lowest location number becomes available. The others are disregarded.