Panasonic KX-TD816 - DID; DDI Extension Name Set

2.2 System Programming
112 General Programming
[139] DID / DDI Extension Name Set
Description
Assigns names to the Direct Inward Dialling (DID) or Direct Dialling In (DDI) extension
assigned in programme [136] DID / DDI Number Assignment.
Selection
• Location number:
001 through 200
• Extension number:
10 characters (max.)
Default
All locations – Not stored
Programming
1.
Enter
139
.
Display: 139 DID NAME
2.
Press
NEXT
.
Display: Location NO?
3.
Enter a
location number
.
To enter location number 001, you can also press
NEXT
.
Display example: 001:Not Stored
4.
Enter a
name
.
For entering characters, see Section 1.4 Entering Characters.
To delete the current entry, press
CLEAR
.
To change the current entry, press
CLEAR
and enter the new name.
5.
Press
STORE
.
6.
To programme another location, press
NEXT
or
PREV
, or
SELECT
and the desired
location number
.
7.
Repeat steps 4 through 6.
8.
Press
END
.
Conditions
• A DID / DDI extension name is displayed only when the Transfer Table is used.
• You can programme the initial display as the DID / DDI extension name in Station
Programming.
Features Guide References
Direct Dialling In (DDI)