2.2 System Programming
General Programming 117
[143] Charge Display Selection
Description
Assigns the initial display format of charge fee.
Selection
in Meter / in Charge
Default
in Meter
Programming
1.
Enter
143
.
Display: 143 CHARGE METER
2.
Press
NEXT
.
Display example: in Meter
3.
Keep pressing
SELECT
until the desired selection is displayed.
4.
Press
STORE
.
5.
Press
END
.
Conditions
• This programming is only effective when you select for charge (SMDR Output) by
programme [816] SMDR Output Mode.
• This programming will also determine the print-out format of the charge fee reference.
Features Guide References
Charge Fee Reference
Display Message
Station Message Detail Recording (SMDR)
To Next Page
Loading...
