2.2 System Programming
124 General Programming
[152] Charge Verification Assignment
Description
Assigns the extension which is allowed to refer or clear for the call information on the
extension, outside line, account code, and the total.
Selection
•Jack number:
KX-TD816 –
01 through 16,
KX-TD1232 –
01 through 64,
( =all jacks)
•
Enable / Disable
Default
All jacks – Enable
Programming
1.
Enter
152
.
Display: 152 CHARGE REF
2.
Press
NEXT
.
Display: Jack NO?
3.
Enter a
jack number
.
To enter jack number 01, you can also press
NEXT
.
Display example: #01:Enable
4.
Keep pressing
SELECT
until the desired selection is displayed.
5.
Press
STORE
.
6.
To programme another jack, press
NEXT
or
PREV
, or
SELECT
and the desired
jack
number
.
7.
Press
END
.
Conditions
• For the KX-TD1232, jack numbers 01 through 32 are for the Master System and 33 through
64 are for the slave, if available.
• To assign all jack numbers to one selection, press the key in step 3.
In this case, the display shows the contents programmed for Jack 01.
Features Guide References
Charge Fee Reference
To Next Page
Loading...
