2.3 Timer Programming
126 General Programming
2.3 Timer Programming
[200] Hold Recall Time
Description
Assigns the length of the hold recall timer. This timer is used to alert an extension that a call
has been held for an extended period of time.
Selection
Time (seconds):
0 through 240
(0=Hold Recall disabled)
Default
60 s
Programming
1.
Enter
200
.
Display: 200 HOLD RECALL
2.
Press
NEXT
.
Display example: Time: 60 sec
3.
Enter the
time
.
To change the current entry, press
CLEAR
and enter the new time.
4.
Press
STORE
.
5.
Press
END
.
Conditions
• Select "0" if Hold Recall is not required.
• You cannot leave the entry empty.
Features Guide References
Call Hold
To Next Page
Loading...
