2.3 Timer Programming
138 General Programming
[212] Call Duration Count Start Time
Description
Sets the number of seconds the system waits between the end of dialling and the start of the
Station Message Detail Recording (SMDR) timer for outgoing toll calls. When the system has
sent out all the digits to the central office and this timer expires, the system starts counting the
call. A display telephone shows the elapsed time of the call. The starting time and the duration
of a call are recorded in the SMDR record.
Selection
Time (seconds):
0 through 60
Default
0 s
Programming
1.
Enter
212
.
Display: 212 CALL TIMER
2.
Press
NEXT
.
Display example: Time: 0 sec
3.
Enter the
time
.
To change the current entry, press
CLEAR
and enter the new time.
4.
Press
STORE
.
5.
Press
END
.
Conditions
• The timer starts counting after all the digits are dialled. This timer does not apply to
incoming calls. The timer for incoming calls starts immediately.
• You cannot leave the entry empty.
Features Guide References
Display Message
Station Message Detail Recording (SMDR)
To Next Page
Loading...
