2.3 Timer Programming
General Programming 141
[215] Outgoing Message Time
Description
Sets the maximum allowable recording time for Outgoing Messages (OGM).
Selection
Time (seconds):
0 / 16 / 32 / 64
(0=no recording)
Default
32, 0, 32, 0 (for OGM 1 through 4 from left to right)
Programming
1.
Enter
215.
Display: 215 OGM MSG TIME
2.
Press
NEXT
to programme the time for OGM 1.
Display example: OGM:32, 0,32, 0
3.
Keep pressing
SELECT
until the desired selection is displayed.
4.
Press to programme the time for OGM 2.
5.
Keep pressing
SELECT
until the desired selection is displayed.
6.
Repeat steps 4 and 5 to programme the time for OGM's 3 and 4.
7.
Press
STORE.
8.
Press
END.
Conditions
• There are four messages available:
OGM 1: used for DISA (Direct Inward System Access) message 1 or UCD (Uniform
Call Distribution) message 1
OGM 2: used for DISA message 2 or UCD message 2
OGM 3: used for Timed Reminder or UCD message 3
OGM 4: used for UCD message 4
• Enter the times starting from the left for OGM 1 to OGM 4.
• The total time of the outgoing messages cannot exceed 64 seconds.
Features Guide References
Direct Inward System Access (DISA)
Outgoing Message (OGM)
Timed Reminder
Uniform Call Distribution (UCD)
To Next Page
Loading...
