2.3 Timer Programming
146 General Programming
[220] TIE First / Inter Digit Time
Description
Assigns the maximum time allowed between the start of the dial tone and the first digit dialled
(First Digit Time), and between digits (Inter Digit Time) on an TIE call. If an extension user
fails to dial any digits during this time, the DTMF receiver is released. This timer applies until
the Toll Restriction check is completed.
Selection
Time (seconds):
3 through 30
Default
5 s
Programming
1.
Enter
220
.
Display: 220 TIE TIMER
2.
Press
NEXT
.
Display example: Time:5 sec
3.
Enter the
time
.
To change the current entry, press
CLEAR
and enter the new time.
4.
Press
STORE
.
5.
Press
END
.
Conditions
• This timer is used for toll restriction checking.
• You cannot leave the entry empty.
Features Guide References
TIE Line Service
Toll Restriction
To Next Page
Loading...
