2.5 Outside Line Programming
174 General Programming
8.
Press
END
.
Conditions
• For the KX-TD1232, outside lines 01 through 12 are for the Master System and outside
lines 13 through 24 are for the Slave, if available.
• To assign all lines to one selection, press the key in step 3. In this case, the display shows
the contents programmed for outside line 01.
• If DTMF is assigned, set the DTMF time of the line in programme [404] DTMF Time.
• If pulse or call blocking is assigned, set the pulse speed of the line in programme
[403] Pulse Speed Selection, and set the pulse break ratio and inter-digit pause in
programme [990] System Additional Information, Area 02 - bit 7, and bits 12 and 11, if
necessary.
Features Guide References
Dial Type Selection
To Next Page
Loading...
