Panasonic KX-TD816 - Pulse Speed Selection

2.5 Outside Line Programming
General Programming 175
[403] Pulse Speed Selection
Description
An outside line set for pulse or call blocking mode in programme [402] Dial Mode Selection
can have two pulse rates, 10 pps (low) and 20 pps (high). This programme sets the pulse speed
for each outside line set to pulse or call blocking mode.
Selection
• Outside line (CO) number:
KX-TD816 –
01 through 08
,
KX-TD1232 –
01 through 24
,
( =all outside lines)
•
10 pps / 20 pps
Default
All outside lines – 10 pps
Programming
1.
Enter
403
.
Display: 403 PULSE SPEED
2.
Press
NEXT
.
Display: CO Line NO?
3.
Enter an
outside line number
.
To enter outside line number 01, you can also press
NEXT
.
Display example: CO01:10pps
4.
Keep pressing
SELECT
until the desired selection is displayed.
5.
Press
STORE
.
6.
To programme another outside line, press
NEXT
or
PREV
, or
SELECT
and the desired
outside line number
.
7.
Repeat steps 4 through 6.
8.
Press
END
.
Conditions
• For the KX-TD1232, outside lines 01 through 12 are for the Master System and outside
lines 13 through 24 are for the Slave, if available.
• To assign all outside lines to one selection, press the key in step 3. In this case, the display
shows the contents programmed for outside line 01.
• The pulse speed required is determined by the outside line or PBX line.