2.5 Outside Line Programming
192 General Programming
[414] Disconnect Time
Description
Determines the amount of time between successive accesses to the same outside line.
Selection
• Outside line group (TRG) number:
1 through 8,
( =all outside line groups)
• Time (seconds):
1.5 / 4.0
Default
All outside line groups – 1.5 s
Programming
1.
Enter
414.
Display: 414 DISCONNECT
2.
Press
NEXT.
Display: TRK GRP NO?
3.
Enter an
outside line group number.
To programme outside line group number 1, you can also press
NEXT.
Display example: TRG1:1.5sec
4.
Keep pressing
SELECT
until the desired time is displayed.
5.
Press
STORE.
6.
To programme another outside line group, press
NEXT
or
PREV,
or
SELECT
and the
desired
outside line group number.
7.
Repeat steps 4 through 6.
8.
Press
END.
Conditions
• The disconnect time must be longer than the requirements of the central office or the host
PBX.
• To assign all outside line groups to one selection, press the key in step 3. In this case, the
display shows the contents programmed for outside line group 1.
• Programme [401] Outside Line Group Assignment is used to assign each outside line to
an outside line group.
Features Guide References
Flash
To Next Page
Loading...
