2.5 Outside Line Programming
General Programming 207
[436] Outside-to-TIE Transfer
Description
Enables or disables transferring an incoming outside call to the TIE line on an outside line
group basis. This restriction applies to the following: 1) A TIE call using DISA 2) Call
Forwarding to a TIE line 3) Call Transfer to a TIE line.
Selection
• Outside line group (TRG) number:
1 through 8,
( =all outside line groups)
•
Enable / Disable
Default
All outside line groups – Disable
Programming
1.
Enter
436
.
Display: 436 CO-TIE XFER
2.
Press
NEXT
.
Display: TRK GRP NO?
3.
Enter an
outside line group number
.
To enter outside line group number 1, you can also press
NEXT
.
Display example: TRG1:Disable
4.
Keep pressing
SELECT
until the desired selection is displayed.
5.
Press
STORE
.
6.
To programme another outside line group, press
NEXT
or
PREV
, or
SELECT
and the
desired
outside line group number
.
7.
Repeat steps 4 through 6.
8.
Press
END
.
Conditions
To assign all outside line groups to the same selection, press the key in step 3. In this case,
the display shows the contents programmed for outside line group number 1.
Features Guide References
TIE Line Service
To Next Page
Loading...
