2.5 Outside Line Programming
General Programming 211
[440] Line Hunting Sequence
Description
Assigns the hunting sequence of idle lines, seizing from the smallest to the largest line number
or vice versa in an outside line group, on an outside line group basis.
Selection
• Outside line group (TRG) number:
1 through 8,
( =all outside line groups)
•
Small
Large / Large
Small
Default
All outside line groups – Small –> Large
Programming
1.
Enter
440
.
Display: 440 LINE HUNT
2.
Press
NEXT
.
Display: TRK GRP NO?
3.
Enter an
outside line group number
.
To enter outside line group number 1, you can also press
NEXT
.
Display example: TRG1:Small>Large
4.
Keep pressing
SELECT
until the desired selection is displayed.
5.
Press
STORE
.
6.
To programme another outside line group, press
NEXT
or
PREV
, or
SELECT
and the
desired
outside line group number
.
7.
Repeat steps 4 through 6.
8.
Press
END
.
Conditions
• The default setting (Small Large) often may cause a busy situation between two PBXs,
as the same line may be seized by both sides simultaneously. In this case, we recommend
changing the setting of either PBX to Large Small.
• To assign all outside line groups to the same selection, press the key in step 3. In this case,
the display shows the contents programmed for outside line group number 1.
Features Guide References
None
To Next Page
Loading...
