2.5 Outside Line Programming
General Programming 219
[448] DID First Dial Start Time (for MFC-R2)
Description
Assigns the number of milliseconds the system waits before dialling a Direct Inward Dialling
(DID) number after an outside line is seized.
Selection
• DID format number:
1 through 8,
( =all DID / TIE formats)
•Time:
1 through 255
( 32 milliseconds is the actual time)
Default
All DID formats – 2
Programming
1.
Enter
448
.
Display: 448 1ST DIAL TM
2.
Press
NEXT
.
Display: Format NO?
3.
Enter a
DID format number
.
To enter DID format number 1, you can also press
NEXT
.
Display example: 1:2
4.
Enter the
time
.
To change the current entry, press
CLEAR
and enter the new number.
5.
Press
STORE
.
6.
To programme another DID format, press
NEXT
or
PREV
, or
SELECT
and the desired
DID format number
.
7.
Repeat steps 4 through 6.
8.
Press
END
.
Conditions
• You cannot leave the entry empty.
• To assign all DID formats to one selection, press the key in step 3.
In this case, the display shows the contents programmed for DID format number 1.
Features Guide References
Direct Inward Dialling (DID)
To Next Page
Loading...
