Panasonic KX-TD816 - Two-Way Recording into Voice Mail

2.8 Resource Programming
272 General Programming
[806-807] Serial Interface (RS-232C) Parameters
Description
Assigns the communication parameters for the Serial Interface (RS-232C) for
Port 1 (for KX-
TD816 and Master System of KX-TD1232)
or
Port 2 (for Slave System of KX-TD1232).
New line code:
Select the code for your printer or personal computer. If your printer or personal computer
automatically feeds lines with a carriage return, select "CR". If not, select "CR+LF".
Baud rate:
A baud rate code indicates the data transmission speed from the system to the printer or
personal computer.
Word length:
A word length code indicates how many bits compose a character.
Parity:
A parity code indicates what type of parity is used to detect an error in the string of bits
composing a character. Make an appropriate selection depending on the requirements of your
printer or personal computer.
Stop bit:
A stop bit code indicates the end of a bit string which composes a character. Select an
appropriate value depending on the requirements of your printer or personal computer.
Selection
• New line code:
CR+LF / CR
(CR=Carriage Return, LF=Line Feed)
• Baud rate (baud):
150 / 300 / 600 / 1200 / 2400 / 4800 / 9600 / 19200
• Word length (bits):
7 / 8
• Parity bit:
None / Mark / Space / Even / Odd
• Stop bit length (bits):
1 / 2
Default
Port 1 / Port 2:
New line code = CR+LF; Baud rate = 9600; Word length = 8;
Parity bit = Mark; Stop bit = 1
Programming
1.
Enter a
programme address (806 for Port 1 or 807 for Port 2).
Display example: 806 RS232C PORT 1
2.
Press
NEXT
to programme new line code.
Display example: NL-Code:CR+LF
3.
Keep pressing
SELECT
until the desired selection is displayed.
4.
Press
STORE.
5.
Press
NEXT
to programme baud rate.