Panasonic KX-TD816 - ISDN Outgoing CLIR Service Assignment

3.3 ISDN Line Programming
ISDN Programming 301
[419] ISDN Outgoing CLIR Service Assignment
Description
Assigns whether ISDN CLIR (Calling Line Identification Restriction) service is enabled or
disabled for outgoing outside calls. If disabled, the subscriber's number of your system is
informed to the called party.
Selection
• Outside line (CO) number:
KX-TD816 –
01 through 08,
KX-TD1232 –
01 through 24,
( =all outside lines)
•
Enable / Disable
Default
All outside lines – Enable
Programming
1.
Enter
419.
Display: 419 ISDN CLIR
2.
Press
NEXT.
Display: CO Line NO?
3.
Enter an
outside line number
.
To enter outside line number 01, you can also press
NEXT.
Display example: CO01:Enable
4.
Keep pressing
SELECT
until the desired selection is displayed.
5.
Press
STORE.
6.
To programme another outside line, press
NEXT
or
PREV,
or
SELECT
and the desired
outside line number.
7.
Repeat steps 4 through 6.
8.
Press
END.
Conditions
• For the KX-TD1232, outside lines 01 through 12 are for the Master System and outside
lines 13 through 24 are for the Slave, if available.
• To assign all outside lines to one selection, press the key in step 3. In this case, the display
shows the contents programmed for outside line 01.
• Programme [418] Outside Line Number Assignment for ISDN / E1 is used to store the
subscriber's number of your system that is informed to the called party.