3.3 ISDN Line Programming
ISDN Programming 309
[424] ISDN Layer 1 Active Mode
Description
Assigns the active mode of Layer 1 on an ISDN port basis.
Selection
• Port number:
KX-TD816 –
01 through 06,
KX-TD1232 –
01 through 12,
( =all ports)
•
Permanent / Call
Default
KX-TD816: Port 05 and 06 – Call; Other ports – Permanent
KX-TD1232: All ports – Permanent
Programming
1.
Enter
424
.
Display: 424 LAYER1 MODE
2.
Press
NEXT.
Display: Port NO?
3.
Enter a
port number.
To enter port number 01, you can also press
NEXT.
Display example: #01:Permanent
4.
Keep pressing
SELECT
until the desired selection is displayed.
5.
Press
STORE.
6.
To programme another port, press
NEXT
or
PREV,
or
SELECT
and the desired
port
number.
7.
Repeat steps 4 through 6.
8.
Press
END.
Conditions
• For the KX-TD1232, port numbers 01 through 06 are for the Master System and 07 through
12 are for the Slave, if available.
• To assign all ports to one selection, press the key in step 3. In this case, the display shows
the contents programmed for Port 01.
• After this assignment, you should reset the system to make this assignment effective.
To Next Page
Loading...
