3.3 ISDN Line Programming
ISDN Programming 311
[425] ISDN Configuration
Description
Assigns the configuration on an ISDN port basis. This programme is available for ISDN
extensions only.
Selection
• Port number:
KX-TD816 –
01 through 06,
KX-TD1232 –
01 through 12,
( =all ports)
•
Point
(point to point)
/ Multipoint
(point to multipoint)
Default
KX-TD816: Ports 05 and 06 – Multipoint; Other ports – Point
KX-TD1232: All ports – Point
Programming
1.
Enter
425
.
Display: 425 ACCESS MODE
2.
Press
NEXT.
Display: Port NO?
3.
Enter a
port number.
To enter port number 01, you can also press
NEXT.
Display example: #01:Point
4.
Keep pressing
SELECT
until the desired selection is displayed.
5.
Press
STORE.
6.
To programme another port, press
NEXT
or
PREV,
or
SELECT
and the desired
port
number.
7.
Repeat steps 4 through 6.
8.
Press
END.
Conditions
• For the KX-TD1232, port numbers 01 through 06 are for the Master System and 07 through
12 are for the Slave, if available.
• If one equipment is connected to the ISDN port, select "Point". If multiple equipment are
connected, select "Multipoint".
• To assign all ports to one selection, press the key in step 3. In this case, the display shows
the contents programmed for Port 01.
To Next Page
Loading...
