3.4 Extension Programming
ISDN Programming 339
[618] CLIP / COLP Number Assignment for ISDN Extension
Description
Selects the type of additional number for the CLIP and COLP information when making and
answering a call through an ISDN line. You can select the type from one of the following:
DDI
: Subscriber number + DDI number
None
: Subscriber number + Optional number
Selection
• Port number:
KX-TD816 –
01 through 06
KX-TD1232 –
01 through 12
• Types:
DDI / Any number, 6 digits (max.)
Default
All ports – DDI
Programming
1.
Enter
618
.
Display: 618 ISDN C/COLP
2.
Press
NEXT
.
Display: Port NO?
3.
Enter a
port number
.
To enter port number 01, you can also press
NEXT
.
Display example: #01:DDI
4.
Press
SELECT
until the desired selection is displayed and enter the number, if required.
To change the current entry, press
CLEAR
and enter the new number.
5.
Press
STORE
.
6.
To programme another port, press
NEXT
or
PREV
, or
SELECT
and the desired
port
number
.
7.
Repeat steps 4 through 6.
8.
Press
END
.
Conditions
• For the KX-TD1232, port numbers 01 through 06 are for the Master System and 07 through
12 are for the Slave, if available.
• To use this programme, "DDI conversion number" must be selected in programme
[990] System Additional Information, Area 06 - bit 13.
To Next Page
Loading...
