2.1 Manager Programming
General Programming 39
Default
KX-TD816:
All jacks – CO buttons 1 through 8 = Single-CO 01 through 08; Ring tone type 2
Other CO buttons = Not stored
KX-TD1232:
All jacks – CO buttons 1 through 24 = Single-CO 01 through 24; Ring tone type 2
Programming
1.
Enter
005.
Display: 005 FLEXIBLE CO
2.
Press
NEXT.
Display: Jack NO?
3.
Enter a
jack number.
To enter jack number 01, you can also press
NEXT.
Display: PT—PGM Mode
4.
Press the
CO button
which is changed to another button.
The display shows the contents pre-assigned to the button.
Display example: CO-01
5.
Enter a
button code
(plus
parameter
, if required).
To change the parameter, press
CLEAR
and enter the new parameter.
6.
Press
STORE.
7.
To programme another CO button of the same jack, repeat steps 4 through 6.
To programme another jack, press
SELECT
and repeat steps 3 through 6.
8.
Press
END.
Cancelling
1.
Perform the same procedures as steps 1 through 4 above.
2.
Enter
2.
3.
Press
STORE.
4.
Press
END.
CO
(Ringer frequency) 1 through 8 (Ring tone type number)
* Available when this system is connected to a Voice Processing System which supports digital
proprietary telephone integration (e.g. KX-TVP100).
Button Code Parameter
To Next Page
Loading...
