5.1 Optional Programming
416 Optional Programming
Selection
• Area code:
01 through 10
• Selection: See
"Selection"
in the explanation table.
09 1 Determines the ring interval time for
incoming calls with Caller ID.
0
: short
1
: normal
1 Caller ID
2 Reserved
4,3 Selects the LED flashing pattern of the
FWD/DND button which indicates the
activating feature (Call Forwarding/Do
Not Disturb).
Reset the system to function this
assignment.
11
: Red Flashing /
Red On
10
: Red On / Red
On
01
: Red On / Red
Flashing
00
: Red Flashing /
Red Flashing
11 • Call
Forwarding
• DND
5-8 Reserved
9 Allows the calling party's number and
name to remain on the display of the
call.
0
: remains the
current display
1
: Call duration
1 Caller ID
10,11 Reserved
12 Permits or disallows the last extension in
a group to log-out.
0
: permit
1
: disallow
1 Log-in / Log-out
13-15 Reserved
16 Determines what should be done with
the call after emitting an alarm because
the Budget Management limit was
reached.
0
: disconnect in 15
secon
1
: do not
disconnect
1 Budget
Management
10 1-8 Sends a dial tone to the extension when
a CO button is pressed or the line access
(Automatic or Outside Line Group)
code is entered to access the E1 line.
This can be assigned for each outside
line group (TRG). The bits 1 through 8
correspond to TRG 1 through 8.
0
: send
1
: not send
1E1 Line
9-16 Reserved
Explanation
Area Bit Description Selection Default Features Guide
References
To Next Page
Loading...
