Panasonic KX-TD816 - Caller ID Name Set

2.2 System Programming
72 General Programming
[111] Caller ID Name Set
Description
With Caller ID Service, the calling party is displayed either by its ID Code or by its name. If
the name display is required, use this programme to give a name to a caller ID Code stored in
programme [110] Caller ID Code Set.
Selection
• Location number:
001 through 500
• Caller ID Name:
15 characters (max.)
Default
All locations – Not stored
Programming
1.
Enter
111.
Display: 111 CALLER NAME
2.
Press
NEXT.
Display: Location NO?
3.
Enter a
location number.
To enter location number 001, you can also press
NEXT.
Display example: 001:Not Stored
4.
Enter a
Caller ID Name.
For entering characters, see Section 1.4 Entering Characters.
To delete the current entry, press
CLEAR.
To change the current entry, press
CLEAR
and enter the new name.
5.
Press
STORE.
6.
To programme another location, press
NEXT
or
PREV,
or
SELECT
and the desired
location number.
7.
Repeat steps 4 through 6.
8.
Press
END.
Conditions
• Caller ID Name corresponds to the Caller ID Codes stored in programme [110] Caller ID
Code Set.
Features Guide References
Caller ID