2.2 System Programming
76 General Programming
Default
LV-MSG – H; GETMSG – *H; AA-SVC – #8; VM-SVC – #6
Programming
1.
Enter
114.
Display: 114 VM DTMF CMD
2.
Press
NEXT
to programme the LV-MSG command.
To programme another command, keep pressing
NEXT
until the desired command is
displayed.
Display example: LV-MSG:H
3.
Enter a
DTMF signal number.
To delete the current entry, press
CLEAR.
To change the current entry, press
CLEAR
and enter the new number.
4.
Press
STORE.
5.
To programme another selection, keep pressing
NEXT
or
PREV
until the desired selection
is displayed.
6.
Repeat steps 3 through 5.
7.
Press
END.
Conditions
• A command signal number can have a maximum of 16 digits, consisting of
0 through 9
, ,
#, FLASH
and
PAUSE.
•The
FLASH
button is available only for LV-MSG and GETMSG commands to store "H"
which means "Home Position".
• If "H" is stored for "LV-MSG", a mailbox number programmed in programme [609] Voice
Mail Access Codes or an extension number will be sent to the VM port (Follow On ID
function). If certain codes are required before and after the ID code, insert "H" between the
codes, as "aaaHbbb". If nothing is stored, it will operate as "H".
• If " H" is stored for "GETMSG", a mailbox number programmed in programme
[609] Voice Mail Access Codes or an extension number will be sent to the port succeeding
the " ".
Features Guide References
Voice Mail Integration for Inband
To Next Page
Loading...
