System Data Clear
After storing or changing the system programming data, it is
possible to clear your programming data stored in the system, if
required. The system will restart with the default setting.
1. Slide the System Clear Switch to the “CLEAR” position.
2. Press the Reset Button with a pointed tool.
3. Return the System Clear Switch to the “NORMAL” position
while the power indicator is flashing (approximately within 10
seconds).
Notice
After pressing the Reset Button, return the System Clear Switch to the
“NORMAL” position at step 3 while the power indicator is flashing
(approximately within 10 seconds). Otherwise, the system is not
cleared.
Installation
2-67
To Next Page
Loading...
